USB Duplicator - Setup Menu - Write Error Skip

Write Error Skip allows you to configure the number of times the system will skip over sectors when it encounters a write error when copying to Target devices. By default, the duplicator will not skip ahead when it encounters any write errors, it will simply result in a duplication job failure. Note: This function does not fix errors; it will skip over the error and continue with copying the remaining data.

The Write Error Skip setting can be changed to one of four options:

Off	Write Error Skip is disabled.  If the duplicator encounters an issue where a USB in the target port(s) is unable to be properly written to then an error will appear.  Note: This is the default setting.
10 Times	If the duplicator encounters an issue where a USB in the target port(s) is unable to be properly written to then the duplicator will attempt 10 times to move beyond that point and proceed with the process.  If it is unable to proceed then an error will appear.
100 Times	If the duplicator encounters an issue where a USB in the target port(s) is unable to be properly written to then the duplicator will attempt 100 times to move beyond that point and proceed with the process.  If it is unable to proceed then an error will appear.
Unlimited	If the duplicator encounters an issue where a USB in the target port(s) is unable to be properly written to then the duplicator will attempt to move beyond that point and proceed with the process.  Note: If it is unable to proceed then no error will appear and you may remain at a specific percentage indefinitely.

To change the Write Error Skip setting:

1. Power on the duplicator.

2. From the Main Menu press the Up or Down buttons until you see Setup.

3. When Setup is displaying for you, press the ENT button to enter this menu.

4. You will be able to access the Setup menu and from here you can use the Up or Down buttons to switch menu options.

5. After locating Write Error Skip, press the ENT button to enter this option.

6. You can use the Up or Down buttons to switch Write Error Skip options.

7. After locating the option, you would like to use, press the ENT button and you will be brought back to the Setup menu.

8. To proceed back to the Main Menu, press the ESC button. This will prompt you with a message informing you that settings are being saved. Once this process is completed, you will be back to the Main Menu.