USB Duplicator - Setup Menu - Size Tolerance

Not all storage devices have identical storage capacity, even when the capacity shown is identical. Normally, the capacity of your Target drives is required to be of equal or greater size than the Source drive so that all data can be copied over without loss. By defining Size Tolerance, the duplicator will allow the Target flash devices to be less than the capacity of the Source drive by the percentage specified.

The setting Size Tolerance has several options to choose from:

Off	When this option is selected, if the target drive(s) contain less capacity then the Source drive the duplication process will fail.  Note: This is the default setting.
1%-5%	When you select a percentage between 1% and 5% the duplicator will take this into consideration when attempting to use a Target USB drive which contains less capacity then the Source drive.  If the Target drive(s) is still out of range then the duplication process will fail.
Ignore	When this option is selected, the duplicator will ignore if the Target drives have less capacity then the Source drive and proceed with the duplication process to the best of its ability.  Note: As this could cause duplicates to be inaccurate, it is not recommended.

To change the Size Tolerance setting:

1. Power on the duplicator.

2. From the Main Menu press the Up or Down buttons until you see Setup.

3. When Setup is displaying for you, press the ENT button to enter this menu.

4. You will be able to access the Setup menu and from here you can use the Up or Down buttons to switch menu options.

5. After locating Size Tolerance, press the ENT button to enter this option.

6. You can use the Up or Down buttons to switch Size Tolerance options.

7. After locating the option, you would like to use, press the ENT button and you will be brought back to the Setup menu.

8. To proceed back to the Main Menu, press the ESC button. This will prompt you with a message informing you that settings are being saved. Once this process is completed, you will be back to the Main Menu.