USB Duplicator - Setup Menu - Erase Prior Copy

When enabled, the duplicator will run an Erase (Quick, Raw, or Secure) on Target devices before copying. Normally the duplicator would simply overwrite the existing data.

Off	Read Error Skip is disabled.  If the duplicator encounters an issue where the USB in the Source port is unable to be properly read then an error will appear.  Note: This is the default setting.
Quick	The fastest erase method. The Quick Erase will erase only the partition table, which will make the device appear empty.
Raw	Raw Erase will perform the same function as a Full Erase in the sense of writing zeros all active sectors on the drive.   The drive partition will additionally be converted to the RAW state after performing the copy.
Secure	Secure Erase uses a three-pass wipe method to thoroughly erase any data on your device and prevents the data from being recoverable. Note: Due to wear leveling technology utilized by most flash memory devices, flash drives may not be securely wiped. Secure Erase should only be run on external HDDs.

To change the Erase Prior Copy setting:

1. Power on the duplicator.

2. From the Main Menu press the Up or Down buttons until you see Setup.

3. When Setup is displaying for you, press the ENT button to enter this menu.

4. You will be able to access the Setup menu and from here you can use the Up or Down buttons to switch menu options.

5. After locating Erase Prior Copy, press the ENT button to enter this option.

6. You can use the Up or Down buttons to switch Erase Prior Copy options.

7. After locating the option, you would like to use, press the ENT button and you will be brought back to the Setup menu.

8. To proceed back to the Main Menu, press the ESC button. This will prompt you with a message informing you that settings are being saved. Once this process is completed, you will be back to the Main Menu.