Mobile Clone - Duplicating from a Storage Center - Loading a Source HDD Image to the Storage Center

Once you have formatted a hard drive as a Storage Center, you can load images of your Source HDDs to the Storage Center. To load a Source HDD image to the Storage Center:

1. Make sure your Storage Center is connected to the side labeled SOURCE and that the Source HDD is connected to the side labeled TARGET.

2. From the Main Menu, tap the SET button to navigate to Load. You will see the following screen:

3. Tap the RUN button. The duplicator will initialize the disks and then ask you to input a name for the image file.

• The file name consists of three digits. The digit furthest to the right will be blinking, indicating that it is currently selected. Tap the RUN button to increase the digit by one.
• Tap the SET button to select the next digit to the left. Tap the RUN button to increase the digit by one. Repeat this step as necessary.

Note: If your duplicator displays the error message, TARGET NOT FORMATTED then the hard drive connected to the SOURCE port has not been formatted as a Storage Center yet.

4. When you have completed naming the image file, hold the RUN button and the duplicator will begin loading an image of your Source HDD to the Storage Center. Note: If the image file name you enter already contains an image file previously loaded on the Storage Center, the system will overwrite the previously saved file.

5. When the load process has completed you can remove the Source HDD from the side labeled TARGET.