The Disable Drives setting allows you to disable a specific Writer drive. This is useful when a drive is producing copies with a high rate of failure or if a drive is not functioning properly. By default, all writer drives are Enabled.
|
1. From the Setup Menu, press the UP or DOWN button to navigate to Disable Drives. Press the ENT button to enter the Disable Drives menu.
|
|
|
2. Press the UP or DOWN button to select a Writer drive. The Writers drives are ordered from the top to bottom (i.e. top most Writer is Drive 1, the Writer below is Drive 2, etc..) Press the ENT button to disable the selected drive or press the ESC button to enable the selected drive.
|
|
|
3. When you have finished enabling/disabling the Writer drives, press the UP or Down button until you see the Save Change screen.
|
|
|
4. Press the ENT button to save the changes. After 2 - 3 seconds the system will prompt you to restart. These changes will not take effect until you restart the system. Press any button to exit to the Setup Menu.
|
Comments
0 comments
Please sign in to leave a comment.