Optical Duplicator Read Error Skip

The Read Error Skip setting allows you to enable the system to skip any read errors it encounters during a Copy process. Normally when the system encounters a read error while reading the master disc, the duplication job will be aborted and all the recordable media will fail (bad copy). If you believe that your master disc has a small, insignificant error due to physical damages; you can turn Read Error Skip to On. The default setting is Off with Retry.

There are three options for the Read Error Skip function:

√ Off - The system will not continue duplicating when it reads a disc error on the master

disc.

√ Off with Retry - The system will attempt to retry duplication if it encounters a read error

on the master disc. If it still cannot duplicate then the copy process will be aborted.

√ On - The system will skip 64KB of data and continue with the duplication process. A

maximum total of 9,600KB is allowed to be skipped over.

√ Turbo Mode - The system will skip 64KB of data and continue with the duplication

process. A maximum total of 65,500KB is allowed to be skipped over.

Note: Turning on Read Error Skip will not fix the error on the master disk, it will only skip it to make the rest of the data readable if possible.

	1. From the Setup Menu, press the UP or DOWN button to navigate to Read Error Skip. Press the ENT button to enter the Read Error Skip menu.
	2. Press the UP or DOWN button to select the Read Error Skip mode. Press the ENT button to confirm your selection. You will exit to the Setup Menu.