Provision Drives to KRMC Hosted Using Kanguru Defender Manager

If your devices are in your possession then you can follow these instructions to manually configure and register your devices with your KRMC Hosted account. If your devices are in the possession of the end user, send a copy of these instructions to the end user along with your KRMC Hosted Account ID and each end user will be responsible for configuring and registering their own devices. Note: Your Kanguru Defender drive must but setup prior to performing the steps described below.

1. Plug your device into the computer and run the KDM application from the device’s CD-ROM partition.

2. Log into the device utilizing the password configured on it.

3. From the Command Console interface, navigate to Settings.  From Settings, select the KRMC Hosted tab.

 4. Once in the KRMC Hosted tab, enable KRMC Hosted by selecting Enable KRMC Hosted.  The field Enter KRMC Hosted ID will become enabled and you must enter your KRMC Hosted Account ID then click on the Verify button.

 

5. If KRMC Hosted was enabled properly, after selecting Verify you should receive a popup stating that the device has been registered to KRMC Hosted.  After seeing this message, the KRMC Hosted tab will no longer be able to be seen on the Defender device.

Your device has now been configured and registered for use with your KRMC Hosted account. Repeat these instructions for each of your Defender devices.

For more information on KRMC Hosted, please refer to the User Manual located at HERE.