Hard Drive Tower Duplicator - Setup Menu - Tran Size

TRAN. SIZE setting allows you define the data transfer block size for each ATA command. Generally, larger transfer block sizes are better for duplication purposes than smaller sizes. However, there are some hard drives which can only accept 2MB data transfer size per ATA command. If your drives only support small data transfer block sizes, then you will need to change this setting.

The Transfer Size settings can be set to 128KB, 256KB, 512KB, 1MB, 2MB, 4MB, 8MB and 16MB. Note: the default value is set to the largest available option for your model.

To change the Transfer Size:

1. Power on the duplicator.
2. From the Main Copy Menu press the Up or Down buttons until you see Setup.
3. When Setup is displaying for you, press the ENT button to enter this menu.
4. You will be able to access the Setup menu and from here you can use the Up or Down buttons to switch menu options.
5. After locating Transfer Size, press the ENT button to enter this option.
6. Press the Up or Down buttons to change the Transfer Size rate.
7. After locating the Transfer Size rate that you are looking to use, press the ENT button to save the setting.
8. Press the ESC button and you will be brought back to the Setup menu.
9. To proceed back to the Main Menu, press the ESC button.

For more information on the Kanguru Hard Drive Tower Duplicator, please refer to the User Manual located at HERE.