Hard Drive Tower Duplicator - Setup Menu - Skip Read Error

The SKIP READ ERROR option allows you to enable or disable error skipping during Disk, Brief, and Resize modes.

Disabled	When an error is detected while reading from the Source, the duplicator will cancel the current process. Note: This is the Default setting.
Enabled	When an error is detected while reading from the Source, the duplicator will skip the bad sector on the Source and fill it with a zero on the Target.

To change the Skip Read Error setting:

1. Power on the duplicator.
2. From the Main Copy Menu press the Up or Down buttons until you see Setup.
3. When Setup is displaying for you, press the ENT button to enter this menu.
4. You will be able to access the Setup menu and from here you can use the Up or Down buttons to switch menu options.
5. After locating Skip Read Error, press the ENT button to alter this option.
6. Press the ESC button after selecting the desired setting to proceed back to the Main Menu

For more information on the Kanguru Hard Drive Tower Duplicator, please refer to the User Manual located at HERE.