Mobile Clone - Duplicating from a Storage Center - Duplicating an IMG Stored on a Storage Center

Now that you have loaded an image file on the Storage Center:

1. From the Main Menu, hold the SET button to enter the Setup Menu.

2. From the Setup Menu, tap the SET button to navigate to the SEL IMG FILE option.

In the example above, file number 001 is currently selected.

3. Tap the RUN button to select an image file.

• The file name consists of three digits. The digit furthest to the right will be blinking, indicating that it is currently selected. Tap the RUN button to increase the digit by one.
• Tap the SET button to select the next digit to the left. Tap the RUN button to increase the digit by one. Repeat this step as necessary.

4. Hold the RUN button when you have completed selecting the image file name.

5. Hold the SET button to return to the Main Menu.

6. From the Main menu, tap the SET button to navigate to the desired copy mode.

7. Connect your Target drive to the side of the duplicator labeled TARGET.

8. Tap the RUN button to execute. Once all connected disks have been detected and initialized, the duplication process begins.

WARNING! Do not remove any drives while duplication is in progress. Wait for duplication to finish before removing a drive. If you wish to interrupt the current process, tap the RUN or SET button at any time.

Note: If you receive the following error message: NO DATA FOUND, then the image file that you selected does not contain any data. Either select a different image file or load the data from a Source HDD to that image file.

9. Once the copy process is completed the screen will either provide you with a Success message or, if for any reason a drive was not duplicated successfully, an error message. Tap the SET button to view the total duplication time.